St. Petersburg, FL

Full Duct Replacement Install Attic Fan Unable to test attic fan due to temperature in attic being to low asked customer to check this afternoon if it comes on

Outdoor disconnect and electrical bypassed. Fittings failed and shorted out high voltage and burnt up disconnect. Will need to replace whip and disconnect for further diagnosis. Replaced outdoor insulation and spliced new wire connections Verified system operations Return to install surge

Remove AFCI ply and install weather resistant GFCI plug for code compliance outlet had no equipment ground

Found the tabs broken off on filter back return grill. Temporarily fixed it with screws and short metal tabs to keep filtered door up. Client may be interested in having a new filter back return grill installed.

Upon my inspection, found 10kw heating kit is only pulling 20 amps and there are burnt up wires. This heating kit is no longer safe to use and will not work properly. Also found a weak capacitor on the condenser unit and smushed coils on the condenser. These are all deficiencies with the 20 year old system. Recommending a Maitenence plan for both systems upstairs and downstairs. Systems appear to have not been maintained properly at this time. ** we do not recommend running the heat on this system as it is a safety hazard. System issues: Bad capacitor Bad heating kit Condenser coils are completely smushed on the back side. Rusted contactar Quote sent for bare minimum repairs. Quote sent for system replacement.

Install customer supplied ceiling fan Trouble shot garage lights they had bad smart switches installed standard switches

Home owners state when running heat the outdoor unit would short cycle and begin to freeze up. Stated indoor started to blow tempid air. Potential outdoor piston clogged Found system reading out of specs subcool of 10. Charged system back to specs. Will monitor if potential leak.

Full System Tuneup Non Permitted Install Home owner also had previous/current rodent issue Air Handler Notes -no primary safety overflow switch -secondary pan no capped -drain line lacking insulation -bacterial growth accumulating inside air handler (blower wheel) -plenums not sealed properly Outdoor Unit Notes -no hurricane tie down straps -outdoor disconnect broken Ducting Notes -damaged 7” flex -damaged main trunk flex -ducts not sealed properly Refrigerant lines not sized properly for system Home is also lacking insulation Bathroom fan on operable (vented in attic/exposed high voltage) home owner states it’s been disconnected

Ruud 3 ton 15 seer heat pump 2 stage system 10 year parts warranty 3 years labor warrantyI -Hurricane pad -Hurricane tiedowns -UV rated armorflex -Electrical whip -Thermostat -New plenums -Seal around return grille with ductboard -Drain pan -Safeties -Flush drain -Insulate exposed piping -Line drier -Vacuum lines under 500 microns -Start up and verify operations **0% interest financing available**

Unit showed f5 error code. Explained to client that pool heaters struggle to heat pools when temps are below 50*. Recommend to replace heat pump with gas pool heater to allow client to heat all year. Unit is operating at this time.

Complimentary duct sanitation

Client states unit not turning on previously. Inspected unit for operation. Tested heating and cooling modes. Temp split in spec. Amp draws on heater good. Blower capacitor in spec. Pressures good. Temp split in cooling 20*. Float switch dry and operational. No issues found today. Unit is heating and cooling properly at this time.

Performed maintenance on two systems. Cleaned and treated drain lines and primary drain pans. Inspected blower motors. Checked fan motor capacitors. Found main living room area AC fan capacitor was weak and found bedroom fan capacitor weak. Replaced capacitors. Fan motor for living room area has oil residue and is amping at 1.46 amps with a rating of 1.45. Notified client that we will have to watch this fan motor and it is at risk of possible failure. System heating at this time. Changed client provided air filters

Pull and clean blower. Clean in place evap coil. Perform maintenance on system. Tax and labor included.

Sound issue client was hearing is due to system going into defrost mode and the reversing valve releasing refrigerant. No problems with this noise. Client signed up for Maitenence plan. Performed first Maitenence on system. Vacuumed drain line and cleaned condens and coils on this first quick Maitenence. Condenser unit was flooded in last hurricane. Found corroded contactar, capacitor, and disconnect at the condenser unit. Replaced all and made new connections. System is over amping on start up pulling 83 amps with a max rating of 72.5. Recommended a soft start kit. Client would like to keep this system running as long as possible. Scope of work performed - Replace condenser disconnect - Replace contactar - Replace capacitor - Make new connections to these components. * No breakdown guarantee due to Unit hurricane flood*

Performed maintenance on one system. Float switch operating properly. All valves operate. Temp split good. Cleared pan and drain. Added chemical to help prevent growth. Replaced filter. Electrical checked good. Unit is operating properly at this time.

Replaced condensate pump for mini split system. Strapped copper condensate line to lineset to prevent excessive rattling. Replaced wiring and plastic tubes. Tested pump and unit. Operations normal at this time.

Replace warranty defrost control board

Upon arrival found thermostat not calling to air handler. Bypassed thermostat and unit began to run. Thermosat failed. Replaced with updated WiFi thermostat (wired and programmed). Verified system operations. Unit is currently working within manufacture specifications.

Replaced breaker and electrical wire in the whip

Inspected unit for loud noise coming from condenser. Found sound was the reversing valve engaging and releasing refrigerant in system during cooling and heating modes. Made client aware that it is a normal operating. Connected thermostat to WiFi for client. Recommend to get regular maintenance on system to help maintain proper efficiency on system. Unit heating and cooling properly at this time.

System is working within manufacture specifications. Verified temp splits, heater operations, checked thermostat settings for thresholds. 5T system for 3,000sf (spray foamed home) Will send estimate to replace single bulb air purifier

Upon my inspection, duct work is not installed properly. Supply plenum is ripped off of Unit even more then last visit January 2nd. Supply plenum need to be completely reattached and strapped up to trusses with two men. Supply plenum needs to be completely sealed. Previous quote given over 30 days ago is Null and Void due to repair becoming more complex as it gets worse. Found return plenum is also allowing attic air to enter the system and need to be re sealed. There is a return duct going to a bedroom that is collapsed due to electrical wire being ran on top of it. This duct is compromised and needs to be replaced. Quotes sent for repairs and full replacement.

Client states unit does not heat well. Found 2400 sqft home with 3.5 ton Goodman unit located in corner of first floor. Pressures good. Temp split good. Capacitors good. Most vents in home are getting minimum air flow. Home is 2 story with poor unit placement. Found thermostat loose on wall as possible cause for unit to be intermittent heating as well. Will discuss possible solutions with owner to decide what is best route for homeowners. Unit is less than 7 years old and is on 3rd motor. Client states to have consistent $1000.00 electric bill each month. Unit is heating to the best of its ability at this time.

Homeowner states outdoor unit making humming sound. Found capacitor reading very weak on compressor side. Replaced and verified operations. Bacterial growth accumulating inside air handler (blower wheel/coils/cabinet) No shutoff disconnect to air handler (code item) Checked temp splits and educated home owner on basic maintenance/filters Unit is currently operating with manufacturer specifications